Hoe is die induksie verwarming oond loaded? :

The workpieces to be heated are manually put into the washboard feeder, and the workpieces to be heated are transported to the nip roller feeding system in a stepwise manner by the washboard feeder, and then the nip roller feeding system sets the workpieces according to the setting A good feed rate is sequentially sent to the furnace body of the induction heating furnace for heating, and the workpiece is heated by the heating inductor. After the heating is completed, the workpiece is quickly transported out by the rapid discharge mechanism for temperature detection to prevent temperature loss . There is an infrared thermometer at the exit of the sensor to detect the temperature of the heated workpiece. After the temperature detection system completes the detection, if the temperature of the workpiece is not enough, the PLC will signal the intermediate frequency power cabinet to increase the power to make the heated workpiece reach The required temperature can be controlled by temperature and power. In the case of overheating, the power of the power cabinet will automatically drop to ensure that the discharge temperature reaches the required temperature. After the temperature detection is completed, the three-position sorting mechanism will send the temperature-qualified workpieces to the next process. The workpieces with unqualified heating temperature, high temperature and insufficient temperature are sorted separately.