- 16
- Feb
What should be paid attention to when using automatic quenching equipment?
À quoi faut-il faire attention lors de l’utilisation équipement de trempe automatique?
Different things need to be noticed in different situations. Of course, you should also pay attention to the corresponding use matters when using the équipement de trempe automatique. Therefore, in order to make the equipment work better, users must not only understand the characteristics of the équipement de trempe automatique, but also The corresponding precautions for use should be mastered. Let’s take a look together below.
1. Be careful not to lack water
When using automatic quenching equipment, the cooperation of cooling water is required, but if the quality of the cooling water is not good, it will easily lead to rust and scale inside the equipment and blockage of the pipeline, and even directly cause the damage of the quenching equipment and fail to work normally. Therefore, when the quenching equipment is used, it must be noted that there is no shortage of cooling water and the cooling water should be clean and free of impurities.
2. Pay attention to keep the circuit intact
There are many circuits in the automatic quenching equipment. If the circuit has a problem, it will cause a serious failure of the equipment. Therefore, when using the quenching equipment, you must pay attention to protecting all the circuits and check them regularly, especially the induction For the circuit of the sensor, it is necessary to avoid short circuit between the sensor and the workpiece during quenching.
3. Pay attention to the proper temperature of the cooling water
The temperature of the cooling water is very important for the cooling effect of the workpiece after quenching. Therefore, when using the automatic quenching equipment, you must pay attention to controlling the temperature of the cooling water, and do not turn off the cooling water in the gap between stopping work. For 100% applications, the temperature of the cooling water should be lower than 40 degrees Celsius, and if conditions permit, soft water should be used as much as possible to avoid scaling in the pipeline.
The market prospect of automatic quenching equipment is very promising and the use effect will directly affect the processing quality of the workpiece. Therefore, manufacturers of quenching equipment hope that users must follow the correct method after purchasing automatic quenching equipment and should also pay attention to the introduction above. At the same time, the equipment should be cleaned regularly.