site logo

What equipment and process flow are needed to make copper ingots into copper rods

What equipment and process flow are needed to make copper ingots into copper rods

Answer: Equipment: melting furnace, casting mold, rolling mill, annealing furnace, cleaning tank, packing table.

Process flow: melting furnace-casting mold-rolling machine-annealing furnace-rolling machine-cleaning pool-packing table.

Takon

Equipment: melting furnace, casting mold, rolling mill, annealing furnace, cleaning tank, packing table.

Process flow: melting furnace-casting mold-rolling machine-annealing furnace-rolling machine-cleaning pool-packing table. …Some of these devices are not needed. The copper used in China is basically waste, and the recycled scrap copper is used in smelting and casting. Some require higher prices, so you must install the buyer’s requirements and add other metal elements in response to the proportion.

Generally, there are two processes for forming copper rods: “extrusion” and “lead casting”

Here I briefly introduce lead casting. Recycling waste copper for smelting and slagging. Insulation lead casting. Pull light to nourish the skin! Straighten. Pack!

For the equipment I need, I have high requirements for installation, and the brackets can be installed according to your own production requirements: Melting furnace holding furnace mold lead casting machine cutting machine heading machine drawing machine straightening machine environmental protection dust removal (spectrometer) You must ensure that you have a 400KV Transformer…how much is the power consumption of a ton of copper? We probably remember about 300-400 kWh of electricity. It depends on the familiarity of your oven master.

If you extrude, you need to buy an extruder. The monthly output is different, the tonnage of the extruder is different. If you use an extruder to extrude, you must buy a round copper ingot… If the output is large, it is recommended to buy a 120KW furnace for heat preservation and smelting. Yes. Squeeze the used copper lead-casting rod by yourself!

As far as the cost is concerned, I personally think that the level of lead casting is relatively small. Extrusion generally adapts to a large amount! Or only use copper materials that require more appearance!