Waa maxay qaababka caadiga ah ee induction heating equipment inductors?

1. The induction heating equipment has a semi-annular crankshaft inductor: it is composed of an effective ring, a spacer, a side plate, a liquid injector, a spacing block and other parts. composed of branches.

2. The induction heating equipment has a longitudinally heated shaft semi-ring inductor: it is a kind of inductor for one-time heating and quenching of straight shafts, stepped shafts, half shafts, etc., which has been widely used since the late 1960s.

3. Camshaft quenching sensor: Because of its special geometry, the current frequency used has a decisive effect on the temperature of the peach tip. There are two types of cam sensors: circular and profiling. Most of the engine cam sensors use circular effective rings.

4. Quenching sensor on the inner surface of the cylinder liner: Scanning quenching is generally used for quenching the inner surface of the cylinder liner. Due to the thin wall of the cylinder liner, when the inner surface is heated and quenched, there is an auxiliary liquid sprayer on the outer surface of the cylinder liner for cooling, which can reduce the amount of cylinder liner. deformed.

5. The induction heating equipment has a short cylindrical heating inductor: it is an inductor for heating short cylindrical workpieces. The effective ring is divided into three layers, the upper layer heats the upper section, the middle layer heats the middle section, and the lower layer heats the low section, and the temperature of each section can be adjusted by adjusting the wrapping angle of each section. The effective ring of this structure can also be equipped with magnetic conductors according to the requirements of different workpieces, and the lowermost effective ring can be slightly modified to heat the fillet and flange surface of the workpiece.

6. Heating inductor of spline part of bell shell: its effective ring is divided into three sections, the upper section heats the upper section of the workpiece cylinder, and the middle section is heated by two columns, which should be equipped with magnetic conductors; the lower forging heating shaft The part can also be added with a magnet.

7. The induction heating equipment has a half-shaft one-time heating inductor: a high-power intermediate frequency power supply is used to harden the half-shaft hardened area at one time. In addition to improving productivity, this method can also be combined with a special quenching machine to combine heating, correction and cooling on one quenching machine.