Introduction to the processing method of epoxy glass fiber board

Epoxy glass fiber board is used to make gears, not only has high elasticity, and there is no noise at high speeds, and the centrifugal force generated is also small. In terms of chemical properties, both epoxy glass fiber board and epoxy phenolic laminate have good stability, corrosion resistance, and are not corroded by chemicals such as acids or oils; they can also be immersed in transformer oil. As parts in the transformer.

Introduction to the processing method of epoxy glass fiber board:

1. Burg’ulash

This is a common processing method in PCB circuit board factories. Whether it is PCB test fixture or PCB post-processing, it will go through “drilling”. Usually the consumables and equipment used in the drilling room are special drilling rigs, drill nozzles, and rubber particles. Wooden backing board, aluminum backing board, etc.

2. Tishlash

This is a common processing method in the market. General stores have a cutting machine to cut the plates, and this is usually relatively rough, and the tolerance can be controlled within 5mm.

3. Freze mashinasi/torna

The products processed by this processing method are usually products such as parts, because milling machines and lathes are mostly used for processing hardware parts, but the slow processing speed of ordinary milling machines and lathes is a feature. However, these two types of equipment are needed. That is to say, if processing thick epoxy glass fiber boards, milling machines and lathes are worth choosing.

4. Kompyuter gong

Computer gongs are commonly referred to as CNC or numerical control, and they are also called machining centers. The scope of bevels is relatively small, while flat computer gongs are more extensive. Small processing parts such as insulating gaskets and insulating rods all use computer gongs. Method of processing epoxy glass fiber board, computer gongs are more flexible, fast, and powerful, and are currently commonly used processing methods.