Induction dumama tanderu kwarara aiki

1. Da hannu aika kayan a ƙarƙashin crane a cikin yankin dumama (an sanya kayan a tsaye). Bayan da crane a cikin yankin dumama ya kasance, an fara buɗe ƙuƙumman maƙallan da tsakiyar hydraulic cylinder na injin injin, sannan kuma za a tura hoist ɗin wutar lantarki don sauke jaws ɗin da kusan 700mm, sannan tsakiyar silinda na hydraulic na tsakiya. an ɗora muƙamuƙi na inji (koma zuwa matsayin asali). A wannan lokacin, na’urar ɗimbin injin za ta manne kayan da kyau kuma a aika zuwa tanderun dumama shigar.

2. Induction dumama tanderun

a. An tsara tanderun dumama a matsayin nau’i na tsaye, maƙasudin shine don yin dumama kayan aiki daidai.

b. Domin yin ɗorawa da saukewa ya dace da aminci, ƙasan tanderun an sanye shi da tallafin ƙasa mai motsi. Ta hanyar silinda na’ura mai aiki da karfin ruwa, ana iya tayar da kayan ta hanyar 1200mm, kuma za’a iya bayyana shugaban kayan 300mm daga saman teburin tanderun.

c. Jimlar tsawon inductor shine 2500mm. Domin yin aikin dumama mafi girma, akwai karkiya a kusa da nada (don hana yaɗuwar maganadisu).

d. Har ila yau, rufin tanderan yana sanye da murfin murhu mai jujjuyawa (don hana zafin zafi), sannan kuma ana samar da ma’aunin zafin jiki na infrared akan murfin tanderun, ta yadda za a iya ganin yanayin zafin jiki a kowane lokaci.

e. Lokacin da crane ya aika kayan zuwa saman tanderun dumama: ɗaya shine don kwance murfin tanderun, ɗayan shine ya ɗaga ƙasa na tanderun zuwa matsayi mafi girma, kuma a hankali sanya kayan a tsakiyar tanderun. Da hannu buɗe ƙuƙumman muƙamuƙi na silinda mai ƙarfi a tsakiyar jaws na inji. Fitar da hawan wutar lantarki, ɗaga farantin injin zuwa wani wuri, kuma crane yana kora.

f. Drive the lifting cylinder to lower the material to the specified position of 1200mm. At this time, turn on the power supply and start heating. After reaching the set heating temperature, when taking the material, the furnace cover is also unscrewed, and the furnace bottom rises. The clamping jaws are opened by the hydraulic cylinder in the middle of the mechanical jaws. After the clamping jaws are in place, the hydraulic cylinder in the middle of the mechanical jaws retracts the clamping jaws, drives the electric hoist, and lifts the heated workpiece away.