Sintering Njira ya Induction Furnace Wall Lining

1. Phimbani nkhungu ya crucible ndi nsalu ya asibesitosi kapena chivundikiro cha ng’anjo, ndikusiya dzenje limodzi lokha, kuti ng’anjo yonseyo ikhale yotentha mofanana kuti ikhale yotentha.

2. It takes 2 hours to slowly heat the furnace to 600°C, keep it here for 1 hour, and then slowly heat up the furnace to 1000°C for 2 hours, and keep it there for 1 hour.

3. After the furnace temperature is naturally cooled to room temperature, step on the furnace shell mold with your foot, and gently hit the furnace shell with a hammer to make the vibration and the furnace wall have a gap, and then slowly take out the furnace shell mold.

4. Onani ngati khoma la ng’anjo lagwa. Ngati pali kugwa pang’ono, mutha kugwiritsa ntchito zida zomangira kuti muwonjezere galasi lamadzi ndi madzi kuti mukonze. Ngati kugwa kwakukulu, khoma la ng’anjo silimangirira mokwanira ndipo ng’anjoyo iyenera kumangidwanso.

5. Ikani chipika chachitsulo mu ng’anjo ndi manja.

6. The furnace must be fully sintered, and the higher liquid level should reach about 100mm away from the furnace mouth to facilitate the overall sintering.