Operation specification requirements for aaladaha bakhtiinta soo noqnoqoshada badan

1. Hawl-wadeenada qalabka dab-demiska ee aadka u sarreeya waa in ay ku guuleystaan ​​imtixaanka oo ay qaataan shahaado qalliin ka hor inta aan loo oggolaan inay shaqeeyaan. Hawl-wadeenku waa inuu yaqaannaa hab-dhaqanka iyo qaab-dhismeedka qalabka, waana inuu u hoggaansamo nidaamka bedqabka iyo isbeddelka;

2. There must be more than two people to operate the high-frequency quenching equipment, and the person in charge of the operation must be designated;

3. When operating the high-frequency quenching equipment, check whether the protective shield is in good condition, and idle people are not allowed to enter during work to avoid danger;

4. Before working, check whether the contact of each part of the equipment is reliable, whether the quenching machine tool is running well, and whether the mechanical or hydraulic transmission is normal;

5. When preparing to turn on the water pump during work, check whether the cooling water pipes are smooth and whether the water pressure is between 1.2kg-2kg. Be careful not to touch the cooling water of the equipment with your hands;

6. The power transmission preheating is performed at the first stage, the filament is preheated for 30min-45min, and then the second stage is performed, and the filament is preheated for 15min. Close and continue to adjust the phase shifter to high voltage. After adding high frequency, hands are not allowed to touch the busbars and inductors;

7. Install the sensor, turn on the cooling water, and drain the workpiece before the sensor can be energized and heated, and no-load power transmission is strictly prohibited. When replacing the workpiece, the high frequency must be stopped. If the high frequency cannot be stopped, the high voltage should be cut off immediately or the emergency switch should be connected;

8. During the operation of the high-frequency quenching equipment, it should be noted that the positive flow and the powder flow are not allowed to exceed the specified value;

9. When working, all the doors should be closed. After the high voltage is closed, do not move to the back of the machine at will, and it is strictly forbidden to open the door;

10. Haddii ifafaale aan caadi ahayn lagu helo habka shaqada ee qalabka daminta-soo-celinta-sare, waa in marka hore la gooyaa tamarta sare, ka dibna waa in la falanqeeyaa oo la tirtiraa.

11. Qolku waa in lagu rakibaa qalabka hawo-mareenka si meesha looga saaro gaaska qiiqa iyo gaaska wasakhda ah ee soo baxaya xilliga deminta iyo ilaalinta deegaanka. Heerkulka gudaha waa in lagu xakameeyaa 15-35 ° C.

12. Ka dib markaad shaqeyso, marka hore ka saar danabka anode-ka, ka dibna jar korontada fiilada, oo sii wad inaad bixiso biyaha 15min-25min, si tuubada elektaroonigga ah si buuxda loo qaboojiyo, ka dibna nadiifi oo hubi qalabka, nadiifi engegan si looga hortago in qaybaha korontadu ay daataan oo la jebiyo. Markaad furto albaabka nadiifinta, ka bixi anode-ka, shabagga, capacitor, iwm.