Løsninger på de interne kredsløbsproblemer i fåreskæreren

mutton slicer is the main equipment for cutting mutton. It is an indispensable equipment for hot pot restaurants. Today’s machines are basically automated, and this is related to the internal circuit. What should I do if there is a problem with the internal circuit?

1. Klip først den løse stålwire af ved den knækkede wire, og lad to ståltrådsender være 10 cm længere end afstanden mellem styrehjulene.

2. Use coarse sandpaper to sand the diameter of the two ends of the steel wire to 1/2-2/3 of the steel wire of the original mutton slicer, and the length should be greater than 5 cm. Use fine sandpaper to smooth the surface of the steel wire, and then use it again. Wash the two steel wire ends with alcohol.

3. De to ståltrådsender med 5 cm sand fjernet overlappes og svejses sammen. Brug en elektrisk loddekolbe til at svejse den ene ende af ståltråden homøopatisk. De to ståltrådsender skal overlappes fuldstændigt, og ståltråden kan ikke vrides. Når jeg står op, kan jeg kun lodde om, og derefter bruge fint sandpapir til at glatte svejsestedet og vaske det med sprit.

4. There must be a long section of the steel wire that is loose, and run the loose section to the rail of the mutton slicer.

5. Divide the length of a wire from the end of the guide wheel by the groove distance of the guide wheel and multiply it by the length of one turn of the steel wire guide wheel.

6. ​​Accelerate every second until the speed reaches normal, and then cut.

If there is a problem with the internal circuit of the mutton slicer, first cut off the power supply and check whether the wire is in good contact. You can solve it according to the above methods and let the slicer run smoothly.